Info needed applying bonnet decal on a 79 A9X Torana

[HSV-XU6]

Hey Guys,

I have recently purchased a 79 A9X Bathurst winner and I have vinyl Marlboro stickers on order.

Now my question is what is involved in applying the bonnet decals properly without damaging the split pins?

http://img51.imageshack.us/img51/8425/294745987o.j pg (http://img51.imageshack.us/i/294745987o.jpg/)

Are they hard to pull out and put back in again and what’s the best way of doing it?

Any helpful advice is much appreciated.

Cheers.

[BB]

Depending on where you got your your decals from, the bonnet decal should have holes pre cut.

[HSV-XU6]

What is the best way to take off the bonnet pins?

[VE II]

Hi

I broke one of my bonnet pins while trying to lay the decals on over the top.

If you open the bonnet, and push with a pin/knitting needle from under the bonnet/pin and push up, it should pop off. Don't twist the pin or pull it - then you'll break it. Once off, apply the decal as best as you can, then make a hole in the decal where the pin is, and reapply the pin. Superglu gel form works, but some people suggest using PVC glue is best.

Hope that helps

[Road Runner 72]

My pins fits back nice n snug without glue ;)

[HSV-XU6]

Cheers guys ill give it a go :)

[slr5000a9x]

thats it, the real cars decal actually sat slightly lower than this decal is though